Guide
The French house pump: sidechain compression on a drum bus
Route the kick into the compressor's sidechain, let it pull the whole bus down on every hit, and set the release so the bus swells back before the next one. That is the pump. This guide sets it up in Thirty-Six, in four DAWs.
Castle 11 Labs ·
The pump
A compressor on a drum bus or a full mix, keyed from the kick instead of from the signal it is compressing. Each kick pushes the detector over threshold, the compressor ducks everything, and the release time decides how fast the level comes back. Time the release to the gap between kicks and the track breathes in rhythm.
Thirty-Six is modeled on the Alesis 3630, the compressor Guy-Manuel de Homem-Christo named in a 2001 Mix interview as the main one Daft Punk used on Homework and Discovery. Thirty-Six adds the parts this technique wants: an external sidechain with high and low pass filters, a Listen button for the key signal, and a Dry level so you can blend the pump under the untouched drums.
The clip below is a drum bus with the kick keyed into the sidechain. Switch between the bus as recorded and the bus through Thirty-Six.
Sidechain routing
Thirty-Six's sidechain input is a bus your host has to switch on and route to. Until your DAW is feeding it, Thirty-Six keeps listening to the track it is on, so an unrouted External sounds exactly like Internal. If nothing changes when you switch to External, the routing is the first thing to check.
Open the Sidechain drawer and set Source to External. Then route in your DAW.
Ableton Live
Put Thirty-Six on the drum bus. Click the triangle at the left of the device title bar to unfold it. Switch Sidechain on and set Audio From to the kick track. Pre FX or Post FX decides whether the kick's own processing shapes the key.
Logic Pro
Put Thirty-Six on the drum bus. In the plugin window header, open the Side Chain menu at the top right and choose the kick track. Logic feeds that track's output to the plugin's sidechain input.
Pro Tools
Put Thirty-Six on the drum bus. Add a send from the kick to an unused bus. In the plugin window, open the Key Input selector and choose that bus. Thirty-Six takes a mono or stereo key.
Reaper
Reaper routes sidechains through track channels. Set the drum bus to 4 channels in its routing window. Add a send from the kick to the drum bus on channels 3/4. In the FX window, open the plugin pin connector (the “2 in 2 out” button) and connect track channels 3 and 4 to Thirty-Six's sidechain inputs.
Key filter
With External routed, press Listen. You hear what the detector hears. If the key is a clean kick, leave the filters out. If the key is a full drum loop or the kick carries a long tail, switch the LPF on and drag its post down until the hats and snare drop out of the key. The live spectrum behind the posts shows what is left. Turn Listen off and the drawer closes.
Gain trims the detector only. Push it up if the kick sits too low to reach threshold. Pull it down if everything is slamming.
Settings
Starting points. Peak mode, hard knee, Stereo link, gate off. Move the release first. It is the control that sets the groove.
- Threshold
- 6 to 10 dB of gain reduction on each kickThe depth of the duck
- Ratio
- 4:1 to 8:1Higher pulls harder for the same threshold
- Attack
- 0.1 to 2 msThe duck should land on the kick, not after it
- Release
- 150 to 300 ms at 120 to 128 BPMShorter than the gap between kicks
- Detection
- PeakRMS averages the kick away and fades out attack and release
- Knee
- HardKeeps the duck sharp
- Sidechain
- External, LPF near 150 Hz if the key is a loopOnly the kick drives the detector
- Dry
- Off for the classic pump, up for a blendMixes the uncompressed bus back under the pump
- Makeup
- Match the bypassed levelJudge the pump, not the volume change
Thirty-Six
$36
Compressor and gate modeled on the Alesis 3630. One-time purchase, two machines, no iLok. The trial is the full plugin for 14 days.
Also on this site: Thirty-Six and the Alesis 3630: what was modeled, what was added
Alesis and 3630 are trademarks of their respective owners, used only to identify hardware whose sounds and behaviors were studied during development. Thirty-Six is not a copy of any hardware unit, and Castle 11 Labs is not affiliated with or endorsed by Alesis.